Supported console modes are
- UART (serial boot mode; RUN = High, RDY = Low)
- USB (serial boot mode; RUN = High, RDY = Low)
Enter USB / UART console mode at netX
Select serial boot mode; RUN = High, RDY = Low
Provide a low level input signal to the RDY pin of the netX 10 to enter the serial boot mode during the powerup phase of the netX 10.
Supported console modes are
- UART
- USB
...
Documentation
For details see section "2.3 System LED and Boot Options" at in the following document.
| Panel | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||
|
Example For an example description for of the jumper at on the development board NXHX10-ETM can be found here, see the following document.
| Panel | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||
|