Supported console modes are
- UART (serial boot mode; RUN = High, RDY = Low)
- USB (serial boot mode; RUN = High, RDY = Low)
Enter USB / UART console mode at netX
Select serial boot mode; RUN = High, RDY = Low
Provide a low level input signal to the RDY pin of the netX 10 to enter the serial boot mode during the powerup phase of the netX 10.Details are described inside chapter
Documentation
For details see section "2.3 System LED and Boot Options" at in the following document.
| Panel |
|---|
| bgColor | white |
|---|
| titleBGColor | default |
|---|
| title | Documentation |
|---|
|
| Page Properties Report |
|---|
| firstcolumn | Page |
|---|
| spaces | DL |
|---|
| headings | Document type, Document title, Content, Date, Language, File type |
|---|
| label | doc070502oi18en |
|---|
| cql | label = "doc101205trgxxen_current_release" and space = "DL" |
|---|
|
|
Example For an example description for of the jumper at on the development board NXHX10-ETM can be found here, see the following document.
| Panel |
|---|
| bgColor | white |
|---|
| titleBGColor | default |
|---|
| title | Documentation |
|---|
|
| Page Properties Report |
|---|
| firstcolumn | Page |
|---|
| spaces | DL |
|---|
| headings | Document type, Document title, Content, Date, Language, File type |
|---|
| label | doc070502oi18en |
|---|
| cql | label = "doc111103hwxxen_current_release" and space = "DL" |
|---|
|
|
