USB driver installation for netX hardware offering a FTDI 2232 USB to SPI controller.

Note:
This installaion ony supports hardware with JTAG and SPM combinations connected to the FTDI chip.
Other combinations like JTAG and COM ports are currently not supported and installed via different installation programs.

Since V3.0.0.0 of the driver installation, the setup now installs both interfaces (MI_00 and MI_01) of the FTDI chip.
The intefaces are alwas defined as:

USB FTDI interface MI_00 => JTAG
USB FTDI interface MI_00 is always connected to the netX JTAG hardware / if available
USB FTDI interface MI_01 => SPM
if SPM via USB is available on the hardware, than it will be always connected to USB FTDI interface MI_01
In an FTDI interface is not connected to the hardware, a dummy entry will be installed, preventing warnings in the windows device manager

Supported hardware:

Board Name	USB ID	Interface installation
NXHX-FTDI	VID1939_&PID_0021	MI_00 = dummy driver MI_01 = USB SPM
NICEB-SPM	VID1939_&PID_0022	MI_00 = dummy driver MI_01 = USB SPM
COMXEB-SPM	VID1939_&PID_0025	MI_00 = dummy driver MI_01 = USB SPM
NRPEB-SPM	VID1939_&PID_0029	MI_00 = USB JTAG MI_01 = USB SPM
NXHX-SDRSPM	VID_1939&PID_002E	MI_00 = dummy driver MI_01 = USB SPM

Browser not supported