netX 90 flasher command line interface (Flasher CLI)

How to use command line to read/write netX 90 internal/external flash?

The Flasher CLI is an open-source command line application for Linux and Windows. It is licensed under GPL-2.0. This tool is integrated into netXStudio.

The Flasher CLI is designed to be used by an advanced user. A GUI interface for the Flasher is provided via the netX Studio.

For more information, please refer to FAQ CLI Flasher

• Page:
  A Raspberry Pi supports multiple SPI signals, which ones are used for communication between RPi and netHAT?
• Page:
  Can other expansion HAT boards be used in combination with the netHAT?
• Page:
  Is other protocol fimware than PROFINET, EtherCAT and EtherNet/IP available for netHAT?
• Page:
  The SYS LED of netHAT flashing alternately yellow and green, is this normal?
• Page:
  How fast can be the data update cycle with an application running above netHAT?
• Page:
  Where can I find API documentation about the netHAT supported protocols?
• Page:
  Is there a 3D CAD model of the netHAT available?
• Page:
  A netX52 chip could support multiple communication channels at a time, does the netHAT support more than one channel?
• Page:
  Can I use netHAT with more than 32 bytes inputs or outputs?
• Page:
  Which operating systems does the netHAT support?
• Page:
  Which SD card size do I require?
• Page:
  Whom should I contact if I have technical questions relating to the netHAT?
• Page:
  Which power supply unit do I require?
• Page:
  Where can I find documentation and further information of the netHAT module?
• Page:
  Supported Flash Types netX100/500