Versions Compared
Key
- This line was added.
- This line was removed.
- Formatting was changed.
Panel | ||||
---|---|---|---|---|
| ||||
What would be checked when maintenance firmware try to install the new loadable firmware? | ||||
Panel | ||||
| ||||
The maintenance firmware (MFW) will check the following information againt firmware(LFW) device header, if they are not identical, the MFW will not install the new firmware. To load the new firmware, the device header of firmware should be changed using Tag list Editor or the information on netX 90 flash device lable (FDL) should be changed accordingly. Manufacture ID Device class Hardware compatiblility Hardware optionsMFW (Maintenance Firmware) is responsible for firmware updates. Before MFW installs the new firmware, it will verify the device header of the new firmware(*.nxi, *.nai or fwupdate.zip) based on the information on the hardware device. If the information on your hardware matches firmware device header information, the new firmware will be installed and then be started automatically. Otherweise, MFW will refuse to install the firmware with an error code. The system led will turn yellow. After power-on reset, the old firmware will start again. |
Panel | ||||
---|---|---|---|---|
| ||||
The following four fields on the hardware device will be validated against firmware device header. The information are defined in FDL (flash device label) and HWC (hardware configuration) on your device.
The first three fields are defined in Basic Device Data of your FDL file. Image Added The Hardware assembly Options are configured in your HWC file. Image Added Image Added Validation for LFW (Protocol stacks)Edit Device Header in netX Tag List Editor Image Added Validation for APP-FW (user application)Device Info are defined in "netx90_app_header.c" of your application. Image Added |
Panel | ||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||
|