Skip to end of banner
Go to start of banner

How to start netX 90 MFW via packet command?

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

Q

How to start netX maintenance firmware via packet command?

A

Use HIL_FIRMWARE_RESET_REQ packet command with HIL_SYS_CONTROL_RESET_MODE_BOOTSTART mode.


The firmware reset request (HIL_FIRMWARE_RESET_REQ → 0x00001E00) has two parameters:

  • ulTimeToReset (unused)
  • ulResetMode

ulResetMode = 0 (HIL_SYS_CONTROL_RESET_MODE_COLDSTART) 

  • The cold start will perform a reset of the device and starts the installed firmware again.

ulResetMode = 2 (HIL_SYS_CONTROL_RESET_MODE_BOOTSTART)

  • The boot start will perform a reset of the device and starts the maintenance firmware. The boot start can be used to start the maintenance firmware without starting an update process (idle mode).

ulResetMode = 3 (HIL_SYS_CONTROL_RESET_MODE_UPDATESTART)

  • The update start will perform a reset of the device and start the maintenance firmware. If a valid update file is available, it will be automatically processed and installed. If no update file is available or if the update file is not valid, the maintenance firmware will automatically start the old firmware.

See also...

  • No labels