Supported console modes are

• UART (console mode; RUN = High, RDY = Low)
• Ethernet (console mode; RUN = High, RDY = Low)

Enter UART / Ethernet console mode at netX

Select console mode; RUN = High, RDY = Low

Provide a low level input signal to the RDY pin of the netX 90 to enter the serial boot mode during the powerup phase of the netX 90.

In order to connect via Ethernet, a DHCP service must be present on the network.

Documentation

For details see section "4.1.3 Console mode" in the following document.

For an example description of the jumper on the development board NXHX 90-JTAG, see the following document.