Manufacturer | Probe | Software | Optional Trace Support | Information |
---|---|---|---|---|
Hilscher | ( |
not NXJTAG-USB/F |
) | netXSTUDIO CDT | |||
Olimex | ARM-USB-TINY-H | netXSTUDIO CDT | ||
Amontec | JTAGKey | netXSTUDIO CDT | ||
iSYSTEM | iC5000, iC5700 | winIDEA | ||
Lauterbach | TRACE32 PowerDebug | TRACE32 | ||
SEGGER |
Debugger |
Debug Connectors
Pinning of debug connectors might differ!
...
Lauterbach Debug Controller
...
LA-3505
...
Lauterbach debug cable and license for netX 90
netX 90 has internal 2x cortex M4
netX 90 has an external 4bit trace port
LA7844 Debug Cable
To use the standard JTAG debugging features use the following license
LA-7844A
...
...
Use this license, if it is the first debugger license for that debug cable.
LA-7844X
...
Use this license, if a debug cable with a valid debugger license exists and this feature should be added
To use the trace port you need either
This debug cable with probe should be used with a fast debugging interface. Either USB3.0 or 1GBit Ethernet. It is also possible to use it with the old USB2.0 debugging interfaces, but this may limit the possible trace features.
LA-4502
or
...
or
This limits the debbuging to cortexM ONLY.
LA-4530
...
Lauterbach Trace license
...
Supports for Embedded Trace Buffer (ETB)
please add the base serial number of your debug
cable to your order
Show Programmable Options
Converter for existing ETM debugger hardware to connect to netX 90 with MIPI-20
Converter to connect a Debug Cable to 10/20/34 pin
connectors specified by MIPI. Converts to CombiProbe
connector
Adaption
SEGGER Programmer | Software for Flasher ARM, Flasher ATE and Flasher Portable |
Debug Connectors
Please refer to the following FAQ page: JTAG connectors and signals