Getting started with netRAPID 90 (Companion Solution - Preloaded communication module)
- Jin Zhao
Owned by Jin Zhao
2019-11-06
2 min read
Loading data...
Q
I've NRP H90-RE\F8D8 (7690.102) module and its evaluation board NRPEB H90 (7600.320) with preloaded firmware, how can I communicate with it?
A
Software installation: (netRAPID 90 DVD 2019-09-1 - BETA: Components - Tools)
- Install the USB_FTDI-SPM driver (NXDIAG) to gain access to the NRPEB H90-RE Evaluationboard via the USB-SPM host interface
→ netX Diagnostic and Remote Access\2019-08-1\netX serial DPM via USB\netX USB FTDI driver installation\Windows\setup.exe - Install the Device Explorer to load or update the Communication firmware on the NRPEB H90-RE
→ Device Explorer V1.2.9.28661 Setup.exe - Install the Device Library
→ Device Library V1.0.41.28658 Setup.exe - Install the Communication Studio to set up a configruation
→ CommunicationStudio V1.0.25.28588 Setup.exe
Detect device NRP H90-RE\F8D8 and check/update firmware with Device Explorer.
(EIS V5.1.0.3 is the pre-installed firmware for NRP H90-RE_F8D8)
Configure NETX_90_RE_EIS (StandAloneSlave) with Communication Studio (IP Settings: Fixed Addresses 192.168.10.2 in the example)
Connect device NRP H90-RE\F8D8 and download the configuration (Device Assignment netX SPM USB Driver)
The basic webserver is available with the configured IP address.
See also...
-
Page:
-
Page:
-
Page:
-
Page:
-
Page:
-
Page:
-
Page:
-
Page:
-
Page:
-
Page:
-
Page:
-
Page:
-
Page:
-
Page:
-
Page: