netX 90 Workshop Training

The LFW - loadable firmware model aims to strictly separate the communication part from the application of a device. The netX 90 is operated with loadable firmware from Hilscher and independently covers fieldbus or Real Time Ethernet communication. Alternatively, the application can now be implemented on the netX 90, used on a dedicated application CPU, or any external host controller. The data exchange between netX communication and application part, or an external host, runs via a dual-port memory implemented in netX. The two chips can be interconnected extremely flexibly via both parallel and serial interfaces.

If your job is to connect the netX 90 to your application or host controller, or to implement an application on the netX 90, then this workshop provides the right content for a smooth start. In both theoretical training blocks and hands-on sessions, you will learn about the netX chip, tools and utilities, the dual-port memory, and the cifX API. After successfully completing the workshop, you have commissioned a netX 90 system, which exchanges cyclic data over the bus with a bus master. You can use the underlying software project you worked on in the practical exercises as a basis for your own development.

The hands-on sessions will be performed on a NXHX 90-JTAG Evaluation Board.

NOTE: EU: 08.10.2024   09:00-13:30 CEST  and 09.10.2024   09:00-13:30 CEST [Int.Ref: SRVINQ-1975]  must be postponed to

=> EU: 15.10.2024   09:00-13:30 CEST  and 16.10.2024   09:00-13:30 CEST [Int.Ref: SRVINQ-1975]

Note: Please contact Hilscher-Sales (sales@hilscher.com) to obtain the actual workshop order form for placing an order.
Hilscher will notify the participants if the minimum number of attendees is not reached and will reserve the right to cancel the event.

The slides and training material are in English. The lectures can optionally be held in English or German. Depending on the composition of the participants, a bilingual mix or entirely in German is also possible.

Please let us know your language preference.

The training is open to everyone and takes place in small groups with a maximum of 12 participants.

EU:  2x Half-Days 09:00-13:30 CET

ASIA: 2x Half-Days 08:00-12:00 CET (or on request)

USA: 2x Half-Days 16:00-20:00 CET (or on request)

Software Developer, project manager

Embedded C programming, basic understanding of micro-controllers and their peripherals